Posted by JIM MN on January 31, 2013 at 12:11:36 from (22.214.171.124):
In Reply to: Clutch ?s posted by mlb-tex on January 30, 2013 at 18:46:40:
Clutch operating sleeve is not going over center to lock in. Check; for worn drive pin and oblong hole in tab of the operating sleeve. If OK; you need three new dogs and three new toggles.Last, check adjustment of the clutch operating rod; the two pads on the clutch collar may be worn, needing to adjust the rod to get the full movement of the operating sleeve so it snaps in .
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.