richardinnz said: (quoted from post at 21:24:30 01/27/13) Coolant pump on a 6068 is belt driven, mounted low down on the front cover, just has a ring of M6 screws holding it in after you have pulled a hose and water tube. Unless the aluminium housing it is bolted to has corroded out behind it then it would be unlikly this is your problem..
Richard
Thanks for the heads up. I was unaware that JD went back to a belt driven WP. I always thought it was "DUMB engineering" to have WP seal fail and dump antifreeze in the crankcase.such as my 4255 has done before. If I researched correctly it appears JD uses this type water pump on several different Mannheim/Saran type engines also
This post was edited by Tx Jim at 04:43:49 01/28/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.