Posted by Hugh McKinney on January 11, 2013 at 07:12:36 from (72.161.82.36):
In Reply to: 4010 LP Question posted by schultz47 on January 11, 2013 at 07:04:48:
The 4010 system, like any properly installed LP system, will have two valves, one liquid (off the bottom of the tank) and one vapor (off the top of the tank), and when LP is pressurized, it will liquify, even if it is introduced in a vapor form, or is introduced in liquid form into the top of the tank (which is normally the only way you can fill the tank.) Do you remember whether you switched it to liquid once you started it? Normally they are started on vapor and then switched to liquid within a few minutes. But nevertheless, it should have run okay to pull a four bottom plow or a baler, vapor or liquid. Sounds like a problem with the system that needed professional attention, not anything that you did wrong. Just sayin'.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.