Posted by NoDakInMN on December 29, 2012 at 11:20:14 from (76.10.68.191):
In Reply to: exhaust manifold posted by terry howell on December 29, 2012 at 09:09:28:
If the position markers have corroded away to the point where they cannot be read, as you indicated, you may have to pull the manifold so you can observe the porting and position it correctly. At this point, since a new heat exchanger is only $30 or so, I would replace it. Since you say you are reconditioning the tractor rather than restoring it, I assume that you intend on using it rather than making it a trailer queen. As such, having the H and C marks would make future adjustment positioning easy and trouble free.
I suppose it could be possible to determine the position of the existing one by taking temp reading on various places on the manifold while the tractor is running, but having never done it, I cannot offer any advice on the feasibility of that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.