Posted by BushogPapa on December 26, 2012 at 11:44:32 from (220.127.116.11):
In Reply to: 620s and 630s posted by RMOMN on December 26, 2012 at 09:49:24:
Carefully Measure the Rt Main Bearing Clearance (with a Dial indicator)... If it has more than Specs, the oil-feed passage under the Rt Main bearing Quill may be blocked..and that also means the Rt Rod will be starving for oil too.. If the Transmission is over-full, it may be engine oil, from that Rt main/Seal, because of excessive bearing clearance..
Put a Load on the PTO and see if it engages or Slips.. Look at the oil in the PTO..it should be 10 Wt oil... If it is 90 Wt, the seal is out... Power Steering..?? Does it work easy both ways..?? Signs of Leaking..??
Intake/Exhaust manifold going bad..?? Gaskets out where it meets the Head on each side..?? (Requires pulling the Head and having it Machined)... Not uncommon for the Intake to be splitting, where the Heat-Crossover meets the intake.. Gauges work..?? Tires..?? Radiator..??
Make sure EVERY Gear is good...and the shifter feels secure and tight.. Would be best to put a Load on it in each gear, actually..
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.