Posted by machinery-man on December 26, 2012 at 08:59:55 from (184.108.40.206):
In Reply to: JOHN DEERE 620 posted by mkr100 on December 25, 2012 at 19:54:24:
JD makes hi altitude pistons in oversize but I dont" know if they made in .125 Extra or excess compression can also be a problem as your carb will have to be calibrated accordingly and your iqnition will be critical. Personally I think it will mess up your burn time on regular fuel. Now if you going exotic fuel, nitro or alcohol I don"t have a clue. I once used Hi altitude pistons in a 520 and couldn"t stand how it ran, way way too much compression and it didn"t run as good as standards that I reinstalled. Cam timing etc is also a factor. Hopping up a 2 cylinder is over my paygrade but there might be pullers that can offer you the right combination, not sure they"re on this site. Good luck.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.