Posted by Mike Aylward on December 02, 2012 at 10:58:09 from (216.145.134.145):
In Reply to: 2520 axle mount duals posted by larryanderson on December 02, 2012 at 04:10:20:
Larry, you will have to do some looking in the parts books. The 2 7/8" axle was used clear back to the model 50 through the 520 and 530. I believe some early 4030's also used this size axle. It may be possible to use the axle wedges from any of the older tractors in the hubs you may have. The taper angle of these hubs was changed at some point so compare the hub casting number with a wheel casting number, such as the common F1500R. Many of those wedges will work in the earlier dual hubs. The later hubs that may have the different taper angle would require a later (and harder to find) wheel wedge. It can be done and has been but you need to be a good student of the parts books. Mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.