Posted by sideconsole4020guy on November 21, 2012 at 04:23:31 from (216.249.194.192):
In Reply to: 224t baler posted by StyledModelB on November 20, 2012 at 16:19:28:
Leave the twine in there. the twine should be throught the needles take the ends and tie them to the bottom of the trip wheel shaft through the chamber then grab the twine infront of the trip wheel shaft, pull 3 ft of twine up, have 2 people keep good pressure on the twine and have a 3rd rotate the baler over and then trip the knotters and watch the needles come up and watch the knotters do there job, the 3rd person will have to be strong and keep the baler moving fast when its tying or the knotters might not work. This is what we do after we work on the knotters or anything on the baler at the shop I work at
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.