Posted by F-I-T on November 09, 2012 at 06:16:53 from (22.214.171.124):
In Reply to: 60 power steering posted by larryanderson on November 08, 2012 at 19:04:02:
Quoting Removed, click Modern View to see
You can hit that shaft pretty hard if you do it smart.
Loosen the cap screw about a turn or 1 1/2 turns, so that you just have a bit of a gap between the gear and the cap screw head. I lay the pedestal on the floor on its side, and hit it square with a sledge hammer, and they always pop off the first thump. I would not use heat. It's a tapered spline fit, so as soon as you thump it, it will pop off. 4 pounds of hammer might not be enough.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.