Posted by rlp on May 09, 2010 at 13:30:53 from (75.252.15.51):
This is my G that I just bought. The motor was stuck and it took a lot of work to get it free. I put a 20 ton jack and put some pressure on the pistons, then I took a crowbar and pryed on the flywheel teeth against the starter. After about 1000 times back and forth I finally made a full round on the flywheel, ha ha I'm going to see if it will run without rebuilding it. I smoothed out a lot of humps and bumps in the bowl areas and opened the intake port from 1 and 3/4" to 2". I might also make a cold intake manifold for it. I would like to get a carburator with a little more air flow but I don't know what to use yet. Sugestions? I wish it had 10&1/2 to one instead of 4&1/2 to one compression ratio; I think I could get 50 hp instead of 38 hp. I wish that I had taken a before and after picture of the head so you could better see the difference. 10 hours of work on the head but no money! Free horsepower, ha ha.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Modern Diesel Fuel in an Old Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.