|
John Deere Tractors Discussion Board |
148 loader and cylinder parts JD Web
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nylon on December 27, 2005 at 15:57:37 from (209.191.208.37):
I can't get the JD website to work. And it is beyond frustrating for someone who gets around on computers pretty well. I had ordered some cylinder parts for 148 loader to repack pistons and seals on lift and bucket. I got 3 different part #s of 4 each after fully explaining what I needed. I needed the piston packings for 2 lift cylinders and 2 bucket cylinders. I also needed the seals for the rod holders. 2 for the lift and 2 for the bucket cylinders. I also asked for any other parts that go in there such as wiper seals. I got 4 wiper seals all the same size. I dont know for sure if the big lift cylinders have wiper seals or just an o ring. Any help with parts diagrams on these part #s would be great. An exploded view of the cylinders would be super. Everytime I tried to get views up on JD parts it would loop back to a default page with no views. I got 4 wiper seals...all 4 of which fit on the bucket rams. I only need 2 that size. (part # re24534) I have 4 of part # r81857. These are the same size/ diameter as the wiper seals so they must fit the bucket rams. And that is it for that size ram. There must be end seals in the rod holder and some type of piston packing. Since they sent 4 does this part # work as both piston packing and rod holder seal? I also got 4 of part # ah212088. These did come with a bit of a diagram. They are called a kit. They seem to be only the o rings for the rod holder seal on the lift cylinders. I got nothing that looks like piston packings. I have not been inside JD cylinders. I have repacked big cylinders on schwartz loader. The packings were heavier rubber matterial rather than these plastic discs. Any help would be greatly appreciated before I call this guy back tomorrow since it is after closing. John
Replies:
Home
| Forums
Today's Featured Article -
Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
