Implement Alley Discussion Board |
Re: Howse 4 ft bush hog
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug Stockman on October 07, 2002 at 03:08:55 from (65.129.152.40):
In Reply to: Howse 4 ft bush hog posted by Shep on October 06, 2002 at 17:18:55:
I use a 4 ft. King Kutter cheap brush hog behind by 1940 Farmall A. It works fine, but it does take a while. I can get 5 acres of 6 ft high "grass" cut in about 4 hours. I have 180 small trees and some rough ground to avoid so it could go faster if it were just flat without obstructions. I actually bought the 3 pt model and used angle iron to connect it to the drawbar initially. I now made a simple 2 and a half point hitch and use a winch to raise and lower the height. Of couse I cannot pick up the entire mower with this setup. The only way this causes a problem is when I am on the road in 4th gear. The one rear cutter wheel has a tendency to flop around and shake everything. Doug Stockman Penfield, NY
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|