FYI, since it's newer than 1911, simply a John Deere drill.
"The two companies consolidated in June of 1911, As many large farm machinery builders did, Deere took advantage of the name, reputation, and good will of their newly-acquired company. Thus, the new grain drills, broadcast seeders, and lime and fertilizer distributers, being sold through the various Deere branch houses all bore the name John Deere-Van Brunt. This was true until about the 1960s, when the Van Brunt name was dropped."
Yes, it looks like a "B" series drill to me. That was one of the first implements I pulled as a kid, with a DEERE 830!
You can view, download or print the parts catalog at the link below.
Do you know what model you have... for instance a "24 X 6" would have 24 openers on 6" spacing.
I took a QUICK look at the parts catalog, and only saw one seed chart part number, M18023 which (unless a closer look at the catalog turns up more options, for different sizes/row spacings) is still available to be ordered through your DEERE dealer for twenty-some bucks.
A manual should have the charts in it, as well. I will look tomorrow... I have quite a pile of drill manuals and there MAY be one for a "B" in there. Otherwise, check Fleabay, or you can get a new one direct from DEERE by calling 1-800-522-7448 (likely about $3000).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.