Jake, If you are saving these moldboards for spares you have no need to worry about wear as they look fine. Unless you are plowing in rocky soil or plowing a lot of acres those parts will last you a long time. I suggest you clean them up, coat them with grease and store then inside and off the ground. Most old plows had a longer landside on the rear bottom. With your setup you probably do not need a tail wheel. Many old plows (such as model #4) used a "solid" tail wheel which was not much more functional than a landside only. As you plow you will find out whether you need a tailwheel. Suggest you take off the extensions and put them on the plow you now use...they do help cover trash and they really have no downside. Hang onto those moldboards...they are better than money in a bank! I wish they were mine. LA in WI
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.