Posted by Billy NY on December 29, 2013 at 04:48:20 from (72.226.79.200):
In Reply to: Good job of plowing!!! posted by JD Seller on December 28, 2013 at 20:34:43:
That is a nice job, all that green going under cleanly, adding nitrogen etc. I suppose the secret to this is matting that grass down before it gets to the plow like the tractor is doing, a more open throat area size plow, correct speed etc. I did not see any coulters, but it looked like there were stems for those on the plow, just the angle of the shot. Its interesting to watch, as I've never had any luck doing that with standing grass or weeds, certainly know it can be done, would prefer it too for the nitrogen value but..... LOL ! actually getting it to work is another thing. Cut that grass it will plug, know how that works LOL ! clean stubble, no problem at all. It may be a matter of adjustment, speed or something, but my 2 bottom 101 ford would seem to make a mess in that, beam to beam I think its 14", new shares are 16" long on it, has coulters.
Where exactly is it that the #9 wire or whatever is mentioned here so often about plowing tall vegetation, attached on a plow to mat the grass or guide it so its covered?
That 6030 is pulling that plow nicely, clean exhaust, no soot plume like it almost does not know its even there LOL !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.