The problem has nothing to do with the knife height. If you set them up last year and have not done that much chopping they should be fine. If the knives still are in the holders completely then they would be the same as new knives in height. You just would have more knife sticking out the bottom of the holders with new ones.
You are plugging behind the screen. That is caused by the corn being too wet. I bet that if you check some of the corn in the green spots it is still almost in the milk stage. That will ball up and plug the chopper up. The fact it is pulling hard should tell you something. IT IS TOO WET!!! LOL
Also I make earledge every year. I never have made it at 35-40% moisture. Your feed guy is book smart but common sense dumb. Wait until your corn is a little drier. If you do not your going to break something on your chopper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.