Posted by showcrop on July 10, 2013 at 05:50:47 from (75.67.231.80):
In Reply to: Boom pole pipe dimension posted by Richard from SE AZ on July 08, 2013 at 14:40:14:
Anyone's idea of medium duty can vary a lot. I don't think that I would make a pole of 1 and1/4 more than four feet long. However you can do similar to what Old suggested but much more so, by taking some bar stock of the same length and say, 3/8 by one inch, put a slight bend in the middle so that it will go over a six inch piece of your tubing that you weld on at 90 degrees to your main pipe right at the middle, and then weld both ends and the middle. That strap will carry a lot of weight. All of the old tractor loaders were built this way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.