Posted by rwskinner on June 22, 2013 at 09:03:16 from (173.219.173.13):
In Reply to: Re: Fasse Multiplier posted by JD Seller on June 22, 2013 at 06:36:59:
Yes, but it's $1000 in parts or $1600 installed.
I'm thinking of this:
Pressure Port 1 from remote to Tee From the Tee go to my cylinder From the side of the Tee, install either an electric valve or manual valve (electric is better since I have a cab) and either plumb the other side to the sump.
Valve close and I have UP Down function, Valve Open I should have float function.
Fasse does make a remote float valve for $450 and it basically does the same thing. 80% float you let it go back to the second port, or for 100% it plumbs back to the sump.
Raking with my 10 Wheel rake, the float really hasn't been a problem. I mowed yesterday with the attached disc mower (JD 275) and it seemed to do fine as well. It seems there is enough play everywhere in the 3 point and also on the disc mower it may not be an issue on fairly level ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.