Posted by lfc on May 24, 2013 at 11:48:19 from (70.233.92.39):
In Reply to: nh 411 discbine posted by playin in the dirt on May 24, 2013 at 08:26:20:
I never used the stand. It took so long for the oil to equalize I found it was easier just to pour in the exact amount of oil - thinking it was 50 oz but check the manual to be sure. I usually engaged the LH transport lock, removed the cutterbar endcap, and set the machine back down to drain the oil. Helps if it is warm, and I"d let it drain for a few hours to make sure the oil from the other end of the cutterbar had time to drain. Just changed the oil in the modules in my new H7230 this week for the first time. The individual modules might be great as far as oil contamination is concerned, but it takes a long time to change them all!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.