Your 60 needs a 3x14" as the largest it will pull and the 70..NOT more than 3x16" My 630 is Fresh and Stout and labors in 2nd with 4x16" and my 720 D is about right with the 4x16"(2nd and 3rd). Our soil is average Clay, Loam with some Jack and Yellow Wax.. I am going to reduce one plow to 3x16" Semi-Mounted.
You can make your own adjustable Gauge Wheel with some basic steel parts, a wheel spindle and a welder.. I have made two and totally agree, the 60 and 70 MUST have the gauge Wheel to control depth.. My last 60 was an "All-Fuel" and would actually NOT pull the 810 3x14" in 2nd gear and 1st is NOT getting anything done..!! A 60 with a Power Block would pull 4x14", I am sure, but they all need GOOD tires and properly placed weights.. Ron.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.