17ft , geee . I have worked on them before when I was a welder for and agricultural engineer but never knew how high they went , only that they went pretty high . I did read some time back in one of the tractor magazines that the F12 loader which was more conventional in the way it went on the tractor could went up to 13Ft ,but then they were fitted a lot further forward on the tractor and if it had a cab , it was no problem . I think they came in in the UK in about 1976 in time for the cab sound decibel regulations . You say about seeing the F25 one tractors with cabs , funily enough only last night I was looking on a site where somebody had one on a John Deere 4020 with what looked like I Hinker cab . Not that I dissbelive you DeltaRed but I am surprised that if you were to fit the F11 on a six cylinder tractor that there still would not be enough space to get a cab on . For what I have seen of them on four cylinder tractors , the Ford 5000 being the most common , there is not much front clearence , so little in fact that if you had no bullgaurd fitted , it meant no front left in the tractor as like I have seen with quite a few . Finally , back to the F25 , am I right in assuming that was never sold here in the UK ? Many thaks to DeltaRed for the responce . David
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.