Posted by ndaircapt on January 18, 2013 at 20:22:31 from (96.3.182.75):
Thanks for all you guys's help over the last week!
Ive learned more about this plow in 72 hours than Ive know in the last 5 years. I took some more pictures close up and hope you can tell me some more information or help date the plow for me. Got the plow in the garage with the 60 - fitting it was no small feat! Soaking all the hardware in "PB Blaster" each day to prepare to take apart if necessary. Also started to shine the front moldboard some. Im still undecided whether to go to the "new" frog and bottom or try to plow with the bottoms I have.
Shares are definately "not sharp" there is about 3/16 of an "edge" Landside on bottom # 1 pretty bad, curved up towards the rear. As you can see in my previous pictures moldboard 1 is broken and welded. #2 landslide pretty good but share in worse shape. did find "JD" cast into both culters but they are different from each other.
"EP 312 EP 314 JD" part # on moldboard. "347 Solid" on the bottom of the share. Is this bottoms right for this plow considering the frame spacing (is it set for 16")? Still alittle confused on this subject.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.