We have a Deere 335 that makes a 4X4 bale and often use it on a 2510 which has the same engine as your 2020.We have used it on our 2040(3 cyc. 40 hp)and it worked ok.We have baled thousands of bales with almost no problems.We have replaced pickup teeth three times and drive chains twice.Cornstalks are very hard on pickups.We still have the original belts but they are completly shot.We bought it new in 1996 at a discount because the 446 balers were introduced to replace the 335. Ours has electic twine so we only need a single outlet hyd system. I would wish for the double twine arm to make it tie faster.We have baled 500-800 hi moisture bales with it and it works ok for that,but you need to be careful that it does not wrap on the drive rolls.Deere made a hi moisture kit with scrappers and we now have one to put on when we replace the belts.I have no complaints about the baler and would only wish for net wrap and the wider pickup which are not options for the 4X4 baler.For us the smaller bale size is great as they are easy to handle and haul.We sell some hay and two bales fit in the back of a pickup and one person can roll them off if need be.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
