Posted by Tim(nj) on November 11, 2012 at 12:55:28 from (184.108.40.206):
In Reply to: 3pt Grain Drill posted by David Schulz on November 11, 2012 at 12:09:14:
first question is why? It is possible to do, you'd simply remove the tongue and attach an a-frame for 3-point in its place. I don't know if you'd still want a way to disengage the seeder drive or not. That might get tricky if it's a clutch lift. On con I can think of is that the drill won't follow the lay of the land as well on 3-point. Front of the tractor goes down, drill lifts up a little, back of the tractor goes down, drill digs a little deeper. Another concern I have is if the frame of an FB is rugged enough to pick up and put down repeatedly without failing.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.