Posted by Don-Wi on November 09, 2012 at 10:50:38 from (22.214.171.124):
In Reply to: Mowing hay posted by Shale on November 06, 2012 at 20:05:19:
It does, but you don't make sharp turns with them. Like I said, to each their own. Big guys around here mostly use large sp units, others use a 30 ft. set up with 1 out front and then another to each side on the back. When making a 90 they have to go all the way past, then back up and turn, then go again. Much faster to do a 180 and not have to shift gears.
With our hydra-swing, (and our conventional haybine)I can stay in the speed i'm at or I can up shift the over/under or multi-power. When turning a 90, you have to slow down, unless you're already going slow because of poor gear selection or because of the constant turns. The key with lands is to make them small enough to not be out of the cut for too long. 6 swaths wide works good for me.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.