Posted by Don-Wi on November 08, 2012 at 20:11:10 from (184.108.40.206):
In Reply to: Mowing hay posted by Shale on November 06, 2012 at 20:05:19:
To each their own. If cutting with our NI 290 side pull, we do 5 or 6 rounds on the headlands, normally 5, and then break it up and do lands that are around 60-100 ft. or so.
With our hydra-swing, we do 4 rounds on the head lands and then back & forth from one side to the other. I've baled for a cousin who would normally cut in lands, but once in a while he would go round & round. Making the corners is a PITA when constantly doing 90's and keeping in the cut/windrow.
You'll never see a big operator going round & round, just don't work with big equipment. We're not big, but still works better for us.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.