Posted by Deere Scotty on November 07, 2012 at 13:31:29 from (184.108.40.206):
In Reply to: Mowing hay posted by Shale on November 06, 2012 at 20:05:19:
We always started at the perimeter, & made 1 continuous path with 90 deg turns. Once completed we drove out from the top, or bottom center where the least amount of hay would be dropped on a line of angled turns heading to a corner of the field. Then we ran the haybine in the opposite direction to cut the area the tractor had to run over on the field edge to finish. Easier to put on paper than said!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.