Posted by chucksoliver77 on November 05, 2012 at 16:26:32 from (220.127.116.11):
In Reply to: plow to plow pics posted by chucksoliver77 on November 04, 2012 at 19:24:38:
JohnDeereJimOhio, it stays on with no fasteners. i took a 2"PVC pine and made a skill saw cut in it and made an angle cut on one end to get it started over the cutting edge and drove it on with a block of wood and a sledge hammer. it stays on fine as long as you don't back drag with it. chuck
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.