Posted by cskent on October 24, 2012 at 17:25:24 from (220.127.116.11):
In Reply to: Woods RM-306 belt posted by Steve in VA on October 24, 2012 at 12:06:24:
Steve, you can go to the woods web site, and print off or just read the operators manual/ parts manual. It goes into good detail on belt tension. You will need to take off the lower belt guard, then you should see the belt and the little indicater, that may need losening and lube to work as they intend. The one on mine was froze up and needed some lube to work as the factory intended. Simple if you have a diagram and parts blow up. All there at the web site. Good Luck.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.