Set it as low a rate as the material will flow through and fill to a marked level and run over a known area and refill and weigh how much it took to do that area. If it only put on 1/4th of what you want repeat and weigh and then do the math. No 2 times will the fertilizer flow exactly the same. Just keep gradually increasing to get where you want and recording what each setting did and where and then after you are completely done with all patches go back over the ones that were light using the figures that you come up with for all settings to get the correct one for to increase the rate put on all of them. You might want to figure the area in say one round at a time in doing the calculations
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.