Posted by Dave Allgire on September 22, 2012 at 06:06:47 from (24.217.34.3):
In Reply to: Farmall Mower #12 posted by Dave Allgire on September 20, 2012 at 15:44:51:
The top gear that is driven by the PTO is on a splined shaft. No slop. The center gear is on an idler shaft with a roller bearing. No slop. The bottom gear, that drives the pitman arm, is also on a splined shaft. No slop. There is no way to tighten up the bottom gear to the idler gear, say by removing shims, as there aren't any. That's where I think there is too much backlash. I guess I'm just trying to be too particular. I'll put it back together with new tapered roller bearings on the upper and lower shafts as well as new seals and run it. Thanks for your response.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.