Posted by Old Iowa on September 11, 2012 at 06:40:09 from (220.127.116.11):
In Reply to: Potato digger posted by nh8260 on September 09, 2012 at 20:43:18:
Do you have it set up so that the digger is free floating???? IF you are trying to have the top link solidly mounted it will not work because it is lifting the rear off the ground when you go over a hump. IF I was three point mounting it I would use a chain linkage in the top link. Then you could set it out long enough to let the digger float.
They had a manual lift system on them. This raised the digger plenty high enough. Is your missing this???
Why don't you pot us some picture of what you have done. That way we can see if we can help you make it work as it is.
To convert it to PTO drive is going to be costly and will more than likely tear it up. The wheels being able to slip is the slip clutch on the old ground driven diggers.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.