Posted by BobH in NH on September 03, 2010 at 18:15:04 from (12.76.200.248):
In Reply to: Ford 530 square baler posted by rwskinner on September 03, 2010 at 16:25:27:
I also have a 532 and, now that I have the knotters straightened out it is a great baler. (One knotter was broken when I bought it, but new parts were included). Ford knotters are much easier to work on than John Deere or NH - You can disassemble, repair and reassemble in the field in under 40 minutes.
One place to check carefully is the flywheel hub, the part which mounts onto the splined input shaft to the gearbox. These are prone to cracking and breaking, especially on the long-tongue version with a center carrier on the pto shaft. Replacement hubs are very expensive, unless you locate someone parting one out.
Pick up teeth from CNH also tend to be very expensive. Mine has the optional individual rubber mounted teeth and 6 bars of teeth. CNH gets $16 and change EACH!! Shoup has identical ones at around $3. Also the flywheel slip clutch discs and the pto slip clutch discs are very expensive from CNH. If I remember correctly, the larger flywheel slip clutch discs were in excess of $75 each (takes 2) and that was 3 or 4 years ago. I found an alternate source from this forum. Message should be in the archives.
Same for drive belts. If I remember correctly the long pick-up drive belt was in excess of $45 from CNH, and around $7-8 from a local bearing/power transmission distributor. His computer had the Ford P/Ns in it with cross refs to Gates and others. Also, he correctly identified the Ford P/Ns as Long Mfg P/Ns - Long built the balers for Ford.
If you buy the baler, email me and I will send you info that I have collected on alternative parts sources.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.