Posted by RalphWD45 on February 17, 2008 at 19:37:56 from (12.144.141.171):
In Reply to: Homemade trencher posted by plowboy1 on February 17, 2008 at 19:07:25:
Most 3pt hitches are in float position, when they are down, and it is normal for them to ride up a little with the contour of the ground, your implement is lowered on. On my AC-B I built my own hydraulics( with the help of Northern Tools), and I have enough down preassure to lift the rear end 6" off the ground, which I did when trying to do the same thing you are doing. I split an oxygen bottle ,in 1/2 long ways, and made myself a rounded edged moldboard, to replace the original, on a 1 bottom 3pt plow. Complete waste of time, and resorses. Finally bit the bullet and rented a trencher,and done the job. Hope you have better luck than I did.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.