It's a 15" wheel for a 6'-0" cutter, looks like the rim comes off, (splits in half vertically) but the axle bearing assembly is still part of the wheel, vs. it being a hub, trying to find a match to that, wide diameter hole with ring of bolt holes, most of what I've seen has a smaller diameter hole, whereas this one is larger, with an entire radius of small bolts holding it to the other half of the rim which has the axle & bearing, vs. the 4 or 5 bolt patterns I keep findinf, they have the smaller dia hole for a hub arrangement if I am correct. It must be a different kind of wheel or specific to Servis-Rhino, worst case it's either super expensive, can't be found and I'll just have to drop another tail/fork assembly in, pin is probably same diameter, could make one too, but really just need a wheel with tire segments.
While searching the net, I finally spotted an operators with parts catalog manual for it, one of the few things I have that I had no manual for, so that might help with part numbers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.