Implement Alley Discussion Board |
Re: PTO U-joint cross bearing removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on November 13, 2006 at 19:05:44 from (4.245.5.216):
In Reply to: Re: PTO U-joint cross bearing removal posted by Paul Schultz on November 13, 2006 at 18:52:19:
99% of the time you have to have both caps out or at least most of the way out to remove the cross bar. Some times you can also use a vise like a press. What you do is put a socket that is a little bigger then the cap on one side and then take a smaller socket and use it to push on one cap. Close up the vise and then tighten it down as hard as you can. Some times hitting the moveable vise jaw with a hammer helps
Replies:
Home
| Forums
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|