Implement Alley Discussion Board |
Re: 3-Point Hitch Standard Dimensions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Sherburne NY on July 26, 2006 at 06:44:37 from (170.215.227.131):
In Reply to: Re: 3-Point Hitch Standard Dimensions posted by Sal Z on July 25, 2006 at 09:33:22:
A while ago someone posted the chart for all these dimensions. I looked for it but can't find it. BUT I did copy it into my computer. I'm not smart enough to get it out and post it. The dimension you want for Category one Are. width 26.8 " to 26.94 between lower pins 18" center to center from lower pins to top link hole. Otherwise known as mast height. width of space at upper hitch point 1.75 inches. The critical dimension is the 18" to high and the rear of the implement raises way high or is it way low. TOO low and it does the opposite.
Replies:
Home
| Forums
Today's Featured Article -
Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|