I put A&I elbow, vertical and horizontal augers, vertical tube and inner horizontal tube on our new to us 1660 before we ran it fall before last. The only issue I had was the bolt holes not quite lining up on the brace of the verticle tube and a few holes on the horizontal tube. I have had pretty good luck with the aftermarket parts from Sloan Express and Shoup. In some cases the parts last better than OEM, I have especially found this to be the case with blades and bearings for our White planter. The one thing to watch for on the elbow is as long as it's greased properly and the truss rod is properly adjusted I doubt that you will wear out the pivot before the elbow gets thin from grain wear unless you only harvest low yielding crops (no corn). The one I took off the 1660 was so thin it had rippled on the back side from the auger being left out. We had changed the elbow on the old 1460 one time as it had worn through the weld in the corner of the elbow and was leaking. While it's all apart I would scatter the gearbox, replace the bearings at least and go through the bottom gear set as well. New bearings on the bottom could save you from the bearing going out on the bottom of the vertical auger and breaking that casting while stripping the gears... Don't ask me why I know that.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
