As I stated, I reduced cylinder speed from 536 which the previous owner had it set, to 386 which is slowest it will go with the three standard sprockets that shipped with machine from factory. With an optional 16 tooth sprocket I could get 325 rpm. I'll see how much one cost, it should not be expensive as it is small. I could get three other sprockets , all much larger and get 312 and 286 rpm, but those large sprockets would be $$$$$ and or the little further reduction in speed , I doubt there being any advantage for the $$$$$.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.