Posted by Averyman on November 01, 2012 at 11:16:34 from (184.108.40.206):
In Reply to: F2 raddle chain posted by johnea4 on November 01, 2012 at 06:50:40:
Are your two drive sprockets at the rear of the raddle in good shape ? I remember that on our G's in peas and flax if the sprockets were badly cupped material would wrap in them and tighten the raddle to a point where the slip clutch would let go. Also, on the bottom pan there are wear strips on either side that can wear through and pieces of it can get bent up and grab the raddle and stop it. Hard to see in there though without removing the raddle...
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.