Posted by Bob Bancroft on November 01, 2012 at 09:43:55 from (22.214.171.124):
In Reply to: F2 raddle chain posted by johnea4 on November 01, 2012 at 06:50:40:
Yes, I would be looking for something else. I suppose there could be ridiculously loose, but too tight could cause more trouble than too loose. Grain dust gets in the joints and actually tightens the chains a little. With the drive chain off you should be able to put a wrench on the nut on the slip clutch and spin the whole raddle assembly around. Do you have a steel curtain hanging midway over the raddle, just about under the load out auger? If that gets bent at all, it retards straw flow enough to plug things.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.