Just a quick update on the 1440. Dad and I were able to pull the combine into the shop (after disconnecting the shafts from the transmission to the drives). I may have blown the money on the new hydro. Apparently there is a bearing out in my transmission. Not too sure of the damage extent yet as I haven't dropped it out. Will be doing that this morning. Several ball bearings fell out when I drained the transmission yesterday evening.
I was sure that the hydro was the culprit before as there was a pretty bad sound coming from it before I replaced it but now I am wondering if my ears are just bad and the sound was actually coming from the tranny.
I appreciate the advice, especially on the replacing the pump and motor at the same time. New to these things so I did not know that. Hopefully can get this puppy back up and running so that when the snow from Sandy goes away we can finish our corn. God bless.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.