Posted by Haywood on January 23, 2009 at 16:15:40 from (67.185.83.238):
This only required a slight Modification to work on this 2008 JD 135LE.
I cut the lower tubes until there was 3 mounting holes left.
I mounted the main Fender Bracket so the tubes would tip downward, this positioned the bar vertically. Used the L brackets supplied in the Kit to mount on the front holes of the tube on each side. The front support installed as viewed in instructions, but I added some plastic fasteners to keep the support from sliding around. The Rear bar Assembly mounted farther Back than pictured for a Craftsman installation. However it was located in the proper location for a good fit. I Plan on buying some Rip Stop nylon and Clear Vinyl & sewing a panel to attach to the rear of the open cab.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.