Posted by Indiana Ken on June 02, 2013 at 05:39:43 from (67.163.32.18):
In Reply to: Ford LGT100 posted by Patrick Klise on June 01, 2013 at 13:03:40:
Is the idler pulley you need mounted on the mower deck or part of the mower drive system and mounted on the tractor? The mowers I have to check for you are a LT 75 which is a 8HP vertical shaft; it uses a short belt from the engine to a jack shaft, the mower drive belt then attaches to the bottom end of the jack shaft to drive the mower blades. The mower deck has two blades...I think (?) this is similar to the LT 100. I also have a LGT 16 which is a horizon shaft engine with an electric clutch for the mower drive. The deck has 3 blades. I can get the pulley sizes for you once I am clear on which pulley.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.