Posted by joe csuti on April 30, 2013 at 17:44:53 from (70.111.202.3):
In Reply to: Ingersoll 3016 posted by Dennis (VA) on April 30, 2013 at 08:54:17:
If this eng has a split intake manifold,2 pc held together with rivets,before condeming carb carefully inspect rivets that hold manifold together,look for loose/broken rivets,if none found then take a can of spray carb cleaner with ext tube & slowly spray around joint while eng running slightly above idle,if eng speed changes while spraying then either gasket bad or rivets loose & manifold sucking air.
You have two choices if mainfold sucking air.
1-Buy a new manifold.
2-If you can pinpoint area of leak try sealing area with red rtv gasket sealer or drill out rivets,clean out joint & seal with rtv sealer & reassemble manifold useing screws,lockwashers & nuts.
Onan eng are prone to this problem as they get older.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.