Posted by joe csuti on December 29, 2012 at 03:37:54 from (70.111.202.184):
In Reply to: Kohlar posted by ShaggyM on December 28, 2012 at 21:35:12:
First check id tag on eng to see if eng a K181(8hp) or K241(10hp)the 110 tractor was made with both eng.
After eng disassembled,take block & crank to a local machine shop that does eng reboreing,have them check bore size of cyl to see if a std size piston will work or if a rebore needed & an os piston set installed,also have them measure crank rod journal to see if within spec's for a std size rod or if crank will need a grind/polish & an undersize rod installed or possibly a new crank needed.
After you find out if eng needs a rebore & possibly an undersize rod(shop will tell you os piston size set needed & also size of undersize rod if needed)you can lookup part#'s at link below,then order parts thru local mower shop,online kohler eng parts store,ebay or online dealers by doing a goggle search for kohler eng parts.You MUST have new piston/rod & take to shop along with block/crank if any machine work needed on eng so new parts can be test fit.
While you're sitting around goto www.kohlerengines.com & download/save & print service/repair manual for K series eng,look in section 1 of manual,it will give you bore size/crank journal size for your eng,write these numbers down & take them with you when you have bore/crank checked at shop.
Other possible options,check small engine warehouse online in repower section to see if a shortblock or other possible eng replacement avail.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.