Posted by George Marsh on October 17, 2012 at 04:39:38 from (220.127.116.11):
In Reply to: Honda GX390 posted by George Marsh on October 16, 2012 at 04:40:23:
Thanks guys, Checked valve clearance, set exhaust to .008. It was at .010. I adjust pressure to zero and no pressure in wand. If there was, it locks up the motor and I would pull the rope out of my hand.
Going to put 10w30 in motor. My problem is I'm getting older. My arm is still hurting 3 days later. Looking for a flywheel and starter or going to give this pressure washer to son and buy one with a starter.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.