Posted by ShadetreeRet on September 23, 2012 at 20:53:21 from (184.4.21.191):
In Reply to: Clutch Tightening Tool posted by Whizkidkyus on September 23, 2012 at 19:21:47:
Kinda depends on the design of the clutch. I am not familiar with new chain saws 'cause it as been about fifteen years since I bought a new chain saw. But yes, years ago some did have a tool available to aid in removing the clutch. Concerning the weed cutters, I have seen quite a few that had a screw that held the clutch drum on the shaft. It was accessed by removing the drive shaft and then removing the screw. The clutch shoe asmbly screws onto the shaft on many models. As I said, kinda depends on how the clutch is designed and made.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.