Joe Csuti: Engine is CV725S. I removed flywheel,and found lower part of punch inside (Was 1/4" Dia by 1" long !!). Found one of 6 curved magnets was not glued to inside of flywheel (Magnet was not damaged, just stucked to little coils around a lot of coils around crankchaft). I think I broke seal/glue when turning flywheel while using puller. Can this magnet be glued back on, or do I buy a new flywheel? All of you have been a great help. Again, this is a great Forum. Thanks from San Diego Ca. Hour meter shows over 1100 hours, used on 5 acres, and still going strong.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.