tires are OK, one of the first things I checked. Blades are on right, really cant mess that up. I did pull the deck and turned the cutting edges to each other, they are off by like 2mm, but the book says thats OK, and it is consistant between the 4 edges. The thing is, when he first started cutting, it was doing fine, nothing he could have hit in this part of my yard. After 5 or 6 "rounds", I noticed it was cutting uneven, but not enough to worry about, the longer he went, the worse it got. I thought maybe the adjusters had come loose or were somehow back down, but the ywere, so I checked the level, and it was off, but when I leveled it back, it made it even worse so I set it back. It not cutting right side to side, like one blade is sitting lower than the other, not just like its higher on one side than the other. This is a new deck, with new spindles and each checked out the same dimensions when I pulled them yesterday. Nw, the old style deck isnt being made, but the new one is identical to the old one, except the way it hangs in the rear, and there was a kit with the new deck to adapt it to work. I did talk to a dealer mech this morning and he told me with this model, you have to level the blades, not the deck, and says that the deck itself sit at an angle, but the blade are level. I dont know at this point....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.